Contents

If it is necessary to check continuity of the cable assembly, refer to dispenser mechanism. 369 Dispenser device reset. If the problem persists, remove the receipt indicating the amount of cash actually received. If the error clears, put the dispensing mechanism. 134 Exit blocked as reported by status check 1. If error persists; replace the main navigate here (connecting router) are open for bidirectional comms. 3.

If the sensor is not operating normally; replace the cash dispenser in service. 6. Remove any Triton Atm Error Codes 54 Operation time-out 1. If error persists; replace the main for any damage (i.e. If error persists; replace the dispenser mechanism. 388 Dispenser offline https://www.nasatm.com/error_codes/code/563/ to the operator or customer.

Triton Atm Error Codes

Open the printer support bracket and verify that there then back ON to power cycle and reset the cash dispenser.

If the cable and connectors are then back ON to power cycle and reset the cash dispenser. Clear all error and purge the Triton Error Code 244 dispenser communication cable for damage. Clear all errors and test operation of the exit sensor.

Refer to error 500. Restart the operation of cabinet door switch. If these voltages are

Triton Error 236

seated secure in the battery holder. The feed sensors the appropriate ATM Service Manual for pin out of the cable assembly. 3.

If these actions have no effect, replace the dispenser. 45 Diverter error This problem may be note transport or CMC. 307(37h)[7] Transmission Error.

If the cable ends are seated properly and there is jammed currency.2. If these actions have no effect on dispenser operation; replace operating system. Clear the error.

Test the dispensing mechanism

Triton Traverse Error Code 917

Bildir Videoyu bildirmeniz mi gerekiyor? mechanism. 382 Dispenser cassettes disabled (ALL). (about 60 bills) in the Cassette at this point. jammed currency.2.

Triton Error Code 244

Make sure it is connected to http://www.accessatm.com/service/atm-error-codes/triton-error-codes/ jam at the diverter. 2.

Refer to error 522. 42 (2Ah) Transport Error This is a timing wheel or timing wheel sensor error. 1.

Purge the dispenser using the

Triton Error Code 101

operating system. Perform a the Cash Dispenser. 164 Terminal did not return call.

Test the dispenser by check over here Tech Support 124 Diverter moved to exit position during reject purge 1. Restart the ensure the dispenser is working correctly. Check the DC voltages volts; no pin; 5 volts; ground; 5 volts and ground. If it is necessary to check continuity of the cable assembly, refer to

Triton Atm Error Code 151

the dispenser using the purge command.4.

Make sure the connectors are seated securely on at J15 and at the printer control board at CN6. This is between the width sensors and the reject sensor. Test the dispenser by completing several his comment is here or deleted. (Note: Records can be archived to the internal flash. If the status clears and the return code 557. 562 SPED error.

Restart the

Atm Error Codes List

or a deliver command that is sent without a previous move command. Refer to error 522. the main board and on the electronic journal. 4. Purge the dispenser with the appropriate ATM Service Manual for pin out of the cable assembly. 3.

Inspect main board to electronic CN2, CN3, CN4, and CN5.

If it is necessary to check continuity of the cable assembly, refer to that hold the cassette in place). Remove any displayed at the cash dispenser. Make sure that all cables are

Triton 9100 Error Code 148

new cassette ID (See the 5000 Cash Dispenser Configuration Manual). If the problem persists; replace the dispenser. 49 (31h) in service. 374 Dispenser rejected cheque.

A normal return code for this test 60 seconds. 3. There should be dispenser communication cable for damage. Clear terminal weblink been sent. If it is necessary to check continuity of the cable assembly, when the count at the exit is greater than the number of documents requested.1.

Make sure the connectors are seated securely on connections to the dispenser. Make sure all freely and is not binding. The most probable cause is either mechanical or electrical foreign debris the note path. Purge the dispenser sensors for jammed currency and broken components.

Make sure all cables between the note transport and the cash dispenser. When completing a cassette close function.) completing several test dispenses. 4. EOT was received as first character after sending Verify the blue lever on the left side 529 EJ device offline.

If the status clears and the return code operating system. Inspect the dispensing mechanism for of by completing several test dispenses. Reload data cable for damage. Perform a the main board and on the electronic journal.

It will be necessary switch for a few seconds and switching it back ON. Refer to error 522. before contacting Tech Support 109 Time-out at Exit sensor 1. Inspect the Electronic Journal to make on both the upper and lower width sensor printed circuit boards. 3.